Scope Process Controls is proud to represent the Heifei Comate Intelligent Sensor Co., Ltd in the Asia Pacific region.  Comate manufacture a range of thermal mass flow and vortex shedding flowmeters for a wide range of applications  These meters truly represent the best value for money in the marketplace when it comes to performance, accuracy, reliability and support!

Ever wanted to gain a better understanding of how much natural gas, compressed air or water you are consuming in your plant but the cost of metering was prohibitive?  With these very competitively priced instruments we can provide you with a flow solution that you never thought was viable.  We are particularly impressed with the thermal mass flow range of instruments for use in difficult applications such as boiler or furnace combustion air flow and wet coal seam gas.  The VFM60 range of vortex meters with integrated pressure and temperature measurement are ideally suited for compressed air and natural gas metering where mass and/or standard flow conditions are required.

Unlike many other suppliers we listen to your specific needs and in many cases we can adapt the meters to meet those needs at little, or sometimes no, additional costs.  If you have a flowmeter application and not sure where to start then please contact us at sales@scopepc.com and we believe that you will impressed with these meters as much as we are.

Compressed Air 

A compressed air system normally includes air compressors, driers, filters pipelines, manifolds etc. As a major power consumer compressed air is an expensive commodity and in many industries can be well over 20% of the total power consumption. There is a lot that can be done to improve the power efficiency of a compressed air system to save energy and maintenance cost. A powerful evaluation system to monitor the flow rate, pressure, power consumption of the compressed air system is important for working out useful means to improve the general efficiency, and further to save energy and cost.

The VFM60 vortex flowmeter with integrated pressure and temperature is the perfect meter for measuring compressed air, natural gas or any other fluid where density changes need to be addressed.

TGF600 Thermal Mass Gas Flow Meter

  • Can be installed/removed without shutting down the system
  • Can be used on pipelines with irregular shapes
  • Minimum flow rate down to 0.3m/s, 100:1 super wide turndown ratio
  • No moving part, almost no pressure loss
  • Direct mass flow measurement, does not require temperature or pressure compensation
  • Isolated design for electrical parts to eliminate interference 
  • Optimised power efficiency design, super low power consumption down to 60mA@24VDC
  • Adapted to any power source
  • 2 lines LCD display with unit display 
  • Standard output is pulse and RS485, Hart@4~20mA and 4~20mA is available
  • Metric/Imperial Unit selectable
  • Password protection function and self-diagnostics

Steam Measurement

Steam is the most commonly used thermal carrier in industry, including power, steel, automotive, textile, chemical etc. It is very important to have reliable and accurate measurement of steam for the users to improve cost saving.

The change of pressure and temperature has great effect on the density of steam. Thus it is very important to implement T&P density compensation to get accurate measurement result of steam

Compared with traditional DP and mechanical meters, vortex flow meter has a clear advantage in steam applications. It can provide accurate measurement in a wide turn down with low pressure loss and less maintenance. That is why the vortex flow meter is the chosen technology for the measurement of steam, especially with steam at temperatures below 350 deg C.

 

Micro Mass Flow Meters

The TGF200 series micro flow meter measures dry air, nitrogen and other non-corrosive gases. They are based on the thermal mass flow measurement technology therefore no temperature or pressure compensation is required.

1) Thermal mass measuring technology, direct mass/standard flow measurement
2) Temperature and pressure measurement as option
3) 6 digit dual line LED screen
4) Low cost economical model.
5) Blue tooth for operating on cellphone
6) 1.5% reading + 0.3% full scale accuracy in 100:1 measurement range
7) 1/4″~2″ (6mm~50mm) small pipe line measurement, G or MNPT thread connection optional
8) On-line diagnostics available